Yes, heat pumps work in winter, and they keep heating UK homes in temperatures well below freezing, down to around minus 15 to minus 20 degrees and lower. They run all year in Scandinavia, where it is far colder than Britain. What changes in a cold snap is efficiency, not whether they work: the system uses a little more electricity to deliver the same warmth. This guide explains how they cope and how to keep winter bills down.
Do heat pumps work in winter? The short answer
Yes. Heat pumps work in winter and keep heating your home in temperatures well below freezing, down to around minus 15°C to minus 25°C depending on the model. A British winter rarely comes close to those limits, so a correctly sized and installed heat pump will keep your rooms and hot water at a steady, comfortable temperature through the coldest months.
The thing that changes when it gets colder is efficiency, not whether the unit works. The heat pump does not switch off or give up when the frost arrives. It carries on extracting heat from the outside air and moving it indoors, just as it does in spring and autumn, only with a little more effort on the very coldest days.
Scandinavia proves the point
If heat pumps could not cope with cold weather, you would not expect to find them everywhere in countries that are far colder than the UK. Yet air source heat pumps are the standard, mainstream heating choice across Scandinavia, where winters are routinely harsher and longer than anything most of Britain experiences.
Norway, Sweden and Finland have some of the highest heat pump adoption rates in the world. Homes there run on heat pumps through deep, sustained sub-zero spells that the UK simply does not see. The technology is mature, proven and built for cold climates. A typical British winter, where overnight lows in most areas sit a few degrees either side of freezing, is comfortably within a heat pump’s working range.
What actually changes in the cold
As the outside air gets colder, the gap the heat pump has to bridge widens. It still has to deliver warm water to your radiators or underfloor heating, but it is now pulling heat from much colder air to do it. That bigger gap means the system works a little harder, so its seasonal efficiency, measured as the SCOP (Seasonal Coefficient of Performance), falls and it uses slightly more electricity to deliver the same warmth.
This is the key point to understand: efficiency dips, but heating does not stop. The table below shows roughly how a modern air source heat pump behaves as the outdoor temperature falls. Exact figures vary by model, home and flow temperature, so treat these as indicative rather than a guarantee.
| Outdoor temperature | Heat output | Rough efficiency (COP) | What it means for you |
|---|---|---|---|
| 7°C | Full rated output | Around 4.0 to 4.5 | Mild day, very efficient running |
| 2°C | Near full output | Around 3.3 to 3.8 | Typical winter day, still strong |
| minus 2°C | Strong output, a little reduced | Around 2.8 to 3.2 | Cold UK day, comfortably coping |
| minus 7°C | Good output on cold-climate models | Around 2.3 to 2.8 | Harsh spell, still heating well |
Even at minus 7°C, a COP of roughly 2.5 means the heat pump is delivering about two and a half units of heat for every unit of electricity it draws. That is still far more efficient than a gas boiler or direct electric heating.
How the heat pump keeps working when it is cold
A heat pump does not burn fuel to make heat. It moves existing heat from outside to inside using a refrigerant, a special fluid that boils at a very low temperature. Because that refrigerant boils well below freezing, there is still usable heat in the outdoor air even when it feels bitterly cold to us. The system absorbs that heat, compresses the refrigerant to raise its temperature, and releases the warmth into your heating circuit.
That is why minus 2°C air is not a problem: there is still plenty of low-grade heat for the refrigerant to capture. If you want the full picture of the cycle, see our guide to how heat pumps work. The same physics that heats your home at 10°C outside is doing the job at minus 5°C, just with a wider gap to close.
Key takeaway
A heat pump does not need warm weather to work. It only needs air that contains some heat, and even freezing air contains plenty. That is the principle that makes them effective right across a British winter.
The defrost cycle, explained
In cold, damp weather you may notice the outdoor unit briefly pause, steam or drip. This is the defrost cycle, and it is completely normal and built in. When the outdoor coil runs colder than the surrounding air, moisture can freeze onto it as frost. A thin layer of frost reduces how well the unit absorbs heat, so the heat pump runs a short, automatic cycle to clear it.
To defrost, the system briefly reverses the refrigerant flow, sending a little warmth out to the coil to melt the frost away. It lasts only a few minutes and then normal heating resumes. You do not need to do anything: the controls handle it for you. A short burst of steam or a small puddle of meltwater beneath the unit is a sign the defrost is working as designed, not a fault.
Cold-climate models and correct sizing
Modern and cold-climate heat pumps are designed to hold their heat output well at low temperatures, so they keep your radiators warm even when the air outside is freezing. The difference between a heat pump that struggles and one that performs all winter usually comes down to design and sizing, not the weather.
A good installer sizes the system to your home’s heat loss at the local design temperature, which across much of the UK is around minus 2°C to minus 3°C. By specifying the heat pump to meet your full heating demand on a day that cold, they make sure it can cope with the coldest realistic days your area sees, with a sensible margin. Key things a quality installer gets right:
- Calculating your home’s actual heat loss room by room
- Choosing a model rated to deliver enough output at the design temperature
- Setting a low, steady flow temperature so the system runs efficiently
- Selecting radiators or underfloor heating sized to that flow temperature
The bodies that set installation standards, including MCS, require certified installers to follow proper sizing and design rules, which is one reason an MCS-certified installer is worth insisting on.
Keeping your winter running costs sensible
Running costs do rise a little in the coldest weeks, which is normal for any heating system. A few habits keep those costs in check:
- Leave the heat pump running low and steady rather than switching it on and off. Heat pumps are most efficient when ticking over gently and keeping the home at a stable temperature.
- Use weather compensation controls, which automatically nudge the flow temperature up and down with the outdoor conditions.
- Keep your flow temperature as low as your radiators allow, since lower flow temperatures mean higher efficiency.
- Consider a dedicated heat pump electricity tariff, which can cut the cost of the extra winter electricity.
For a fuller breakdown of what you can expect to pay, see our guide to heat pump running costs, and the independent advice from the Energy Saving Trust is a useful sense check too.
Busting the “they cannot cope with a UK winter” myth
A common myth is that heat pumps cannot keep a home warm during a British winter. It tends to come from a handful of cases where a system was undersized, badly installed or run on the wrong settings, then blamed on the technology itself.
In practice, a correctly sized and installed system keeps a home at a steady, comfortable temperature all year round, including hot water, through frost, wind and rain. The cold-weather complaints you sometimes read about almost always trace back to poor design rather than the heat pump being unable to do the job. Get the sizing and installation right and the British winter is well within reach.
How winter performance affects whether a heat pump is worth it
Winter is exactly when a heat pump earns its keep, because it is the season you rely on heating most. A system that holds its output through the cold and stays reasonably efficient is the difference between a heat pump that pays off and one that disappoints. That is why the quality of the install matters as much as the technology.
If you are weighing up the decision overall, including the upfront cost, the available grants and the long-term savings, our guide on whether a heat pump is worth it brings the full picture together. Confident winter performance is one of the strongest arguments in a heat pump’s favour, provided it is specified properly for your home.
How Energy Saving Hub helps you find the right installer
Because so much of winter performance comes down to sizing and design, the installer you choose is the single most important decision you will make. Energy Saving Hub is a comparison service, not an installer. We match UK homeowners with accredited, MCS-certified installers who carry out a proper heat loss calculation and size your system to cope with the coldest realistic days in your area.
You tell us about your home, and we connect you with trusted local installers who can quote, advise on the right model for your property and make sure the system is designed to keep you warm all winter. Comparing quotes from more than one installer also helps you understand your options and get a fair price.
So, do heat pumps work in winter?
Yes, clearly and reliably. Heat pumps keep heating homes well below freezing, they are the everyday choice across colder countries than ours, and the only thing the cold changes is a modest dip in efficiency rather than whether the system works. The defrost cycle is normal, cold-climate models hold their output, and correct sizing to your local design temperature is what makes the difference. Choose a well-designed system and a quality installer, and a British winter is comfortably within a heat pump’s stride.
Frequently Asked Questions
Do heat pumps work in winter?
Yes. Heat pumps work in winter and keep heating your home in temperatures well below freezing, down to around minus 15°C to minus 25°C depending on the model. They are the standard heating system across Scandinavia, which is far colder than the UK, so a correctly sized and installed unit copes easily with a British winter.
Do heat pumps work in cold weather?
Yes, and they do it well. Even freezing air contains usable heat, which the refrigerant captures and moves indoors. What changes in cold weather is efficiency, not whether the system works. As the air cools, the SCOP falls slightly and the heat pump uses a little more electricity to deliver the same warmth, but it keeps heating.
At what temperature do heat pumps stop working?
Most heat pumps keep working down to around minus 15°C to minus 25°C, depending on the model. A British winter rarely comes near those limits, so the unit will not stop heating your home. Efficiency dips gradually as it gets colder, but the system continues to deliver warmth and hot water throughout.
Are heat pumps more expensive to run in winter?
Running costs rise a little in the coldest weeks, which is normal for any heating system. You can keep bills sensible by running the heat pump low and steady, using weather compensation controls, keeping a low flow temperature where possible, and considering a dedicated heat pump tariff to offset the extra winter electricity.
Do heat pumps freeze?
Frost can form on the outdoor coil in cold, damp weather, but the heat pump handles it automatically. It runs a short defrost cycle that briefly reverses the flow to melt the frost away, then resumes normal heating. A puff of steam or a small puddle beneath the unit is normal and shows the defrost is working.
Will a heat pump keep my house warm?
Yes. A correctly sized and installed heat pump keeps a home at a steady, comfortable temperature all year, including hot water. The key is proper design: a good installer sizes the system to your home’s heat loss at the local design temperature, around minus 2°C to minus 3°C in much of the UK, so it copes with the coldest realistic days.
Why does my heat pump steam in winter?
That steam is the defrost cycle at work. When frost builds on the outdoor coil, the heat pump briefly sends warmth out to melt it, which produces visible steam and sometimes a little meltwater. It is completely normal, built into the controls, and lasts only a few minutes before normal heating resumes. No action is needed from you.
Get a Heat Pump Sized for a UK Winter
Compare quotes from accredited, MCS-certified installers who size your system for the coldest days, not just mild ones.
Published June 2026. The figures in this guide are typical UK ranges for 2026 and are intended as a guide; your own numbers depend on your home, so request a tailored quote for exact costs and savings.


